1. Product Basics
- Weight Including Packaging: 81.3 Grams
- Packaging: Thin Corrugated Colour Box
- Material: Abs plastic
2. Product Parameters
- Battery Capacity: 500 Milliampere-Hours
- Working Temperature: 0 Degrees Celsius To 50 Degrees Celsius
- Standby Power Consumption: Less Than 20 Microamperes
- Hibernation Power Consumption: Less Than 150 Microamperes
- Working Current: 11 Milliamperes
- Charging Current: 500 Milliamperes
- Volume Settings: Mute/Vibration; Loud 90 To 100 Decibels; Quiet 70 To 80 Decibels
3. Operation Instructions
- Gravity Mode (Mode 1): Flip The Switch To This Mode. Flip The Device With The 5 10 30 Or 60 Minutes Side Up To Start Countdown. Flip The Screen Up To Pause And Flip The Screen Down To Reset The Timer.
- Manual Mode (Mode 2):
- Positive Counting:
1. When The Display Shows 00:00 Short-Press The [Sp/St] Key To Start Positive Counting.
2. During Counting Short-Press The [Sp/St] Key To Pause Or Resume.
3. In Pause State Long-Press The [St/Sp] Key To Clear.
- Countdown Setting:
1. Short-Press The [M/S] Key To Incrementally Adjust The Countdown Time. Long-Press For Rapid Adjustment. After Setting Short-Press The [Sp/St] Key To Start.
2. During Counting Short-Press The [Sp/St] Key To Pause Or Resume.
3. In Pause State Long-Press The [St/Sp] Key To Clear.
4. When The Countdown Reaches 00:00 There Will Be A One-Minute Alarm. The Alarm Cycles Between "Beeping With Led On" And "Sound Off With Led Off" In One-Second Intervals. In Mute Mode There Is A Vibration Alert.
5. Memory Mode: After Countdown Ends Short-Press The [Sp/St] Key Again To Show The Set Time. Long-Press The [St/Sp] Key To Clear. Short-Press To Cycle.
4. Precautions
- The Product Will Auto-Hibernate If There Is No Operation For Five Minutes.
- The Alarm Duration Is One Minute After Positive Or Countdown Ends.
- After Hibernation In Gravity Mode It Can Be Used By Flipping; In Manual Mode It Can Be Adjusted By Pressing.
- In Mute Mode There Is Vibration Feedback At The End Of Timing Or For Any Operation. In Volume Mode There Is A Beep Feedback For Operations.
- When The Battery Level Is Below 10 Percent The Screen Flashes To Remind Charging. The Charging Indicator Is Red During Charging And Turns Green When Fully Charged.
